FROM DIFFICULT TO SIMPLE – THE WAY TO EFFICIENCY DOI: 10.22184/2499-9407.2020.21.04.18.19
CONFERENCE "PROBLEMS OF IMPLEMENTATION OF THE CONCEPT "INDUSTRY 4.0" IN HONOR OF THE 5TH ANNIVERSARY OF STANKOINSTRUMENT MAGAZINE
DIRECTIONS OF DEVELOPMENT OF METAL-CUTTING MACNINES: SYSTEM PRINCIPLES. PART 2 DOI: 10.22184/2499-9407.2020.21.04.36.45
The article considers the mechanisms for increasing the efficiency of creating new, more progressive and innovative technological equipment based on the cycles' analysis of the evolutionary process of the development of production technological methods in relation to the continuous improvement of machine tools designs, their components and subsystems.
DETERMINATION OF TECHNOLOGICAL CAPABILITIES OF VERTICAL MILLING CENTER DOI: 10.22184/2499-9407.2020.21.04.48.52
The article shows the determination of the technological capabilities of a vertical milling center for the manufacture of modules of parts surfaces.
FAILURE OF A SINGLE CRYSTAL UNDER THE IMPACT OF A CURRENT DOI: 10.22184/2499-9407.2020.21.04.54.55
The article researches fractographic features of fractures of a high-purity Al single crystal after stretching with the introduction of single current pulses, multi-pulse current and without current. Fractographic analysis of fractures indicates the healing of microcrystalline defects with the introduction of a multi-pulse current in comparison with the samples tested with single pulses and without current.
THE TECHNIQUE FOR DESIGNING TURBINE BLADE PROCESSING IN A MODERN CAM SYSTEM BY THE EXAMPLE OF WORK IN THE CAM ADEM SYSTEM DOI: 10.22184/2499-9407.2020.21.04.56.63
The article presents one of the methods for specifying milling transitions when machining turbine blades, based on the ability to divide the processing zones and use the optimal tool for each zone.
LABORATORY ANALYSIS OF LABRICANT-COOLING FLUIDS. PART 2 DOI: 10.22184/2499-9407.2020.21.04.64.67
The article presents an overview of the most important tests and methods of laboratory analysis of complex and multicomponent lubricants, including water-miscible cutting fluids.
THE TECHNIQUE FOR THE SYNTHESIS OF INSTALLATION GROUP INSTRUMENTAL SETTINGS. PART 1 DOI: 10.22184/2499-9407.2020.21.04.68.74
The article considers a technique for designing group settings for scientifically grounded development of a computer-aided design (CAD) system for optimal group technological processes (GTP). It gives the principles of the design of group instrumental settings (GIN), the technique of formalized selection and synthesis of the GIN optimization process. The article presents table-matrix for the selection of the GIN installation kit.
ALGORITHMS MODELING FOR CONTROL OF MOBILE ROBOTS GROUPS BY MEANS OF THE FUNCTIONAL-VOXEL METHOD DOI: 10.22184/2499-9407.2020.21.04.76.81
The article considers an example of a description of one of the algorithms for decentralized navigation of large groups of ORCA agents by means of the functional-voxel method, as well as the case of constructing an area of permissible speeds to prevent collisions for two mobile robots. On the basis of graphic image models, an approach has been developed for constructing the area of permissible speeds of robots on a plane.
METHODOLOGICAL APPROACHES TO CREATION OF EFFECTIVE TECHNOLOGIES FOR TRAINING MECHANICAL ENGINEERS DOI: 10.22184/2499-9407.2020.21.04.82.87
The article presents an experience of the Omsk State Technical University in the creation of an educational, research and production center "Modern technologies of mechanical engineering". It describes the necessary conditions for the training of in-demand personnel for modern production at the basis of the center. The article summarizes 10-year experience of the STM URPC.